|
|
 |
|
 |
-
Fuse Box Wiring Module
-
Hard Wire the Car Camera
Directly to the Fuse Panel
With this accessory you can hard
wire the car camera directly to
the fuse panel. The wiring
harness has a power sensor that
will stop the camera from
recording if it depletes the
battery below a certain point.
|
Model:
SCI-DR200-WM |
Price: $19.99 |
 |
|
|
 |
|
|
Fuse Box Wiring Module - Installation Guide |
|
|
 |
-
Step 1
-
Locate Vehicle's Fuse
Box
Open the Vehicle fuse box.
Locate a fuse that has constant
power. In general, Break light,
emergency light and inside light
are used |
|
|
|
|
|
|
 |
-
Step 2
-
Check Vehicle's Voltage
Battery voltage may vary from
vehicle to vehicle. Insure the
vehicle's voltage is within the
operating voltage range of the
device being installed. |
|
|
|
|
|
|
 |
-
Step 3
-
Determine Positive Constant
Fuse Location
Choose a fuse location that is
constantly energized (hot) for
proper operation. Indicator light on
tester determines if location is
energized. Side is + (Positive), the
other is - (Negative). |
|
|
|
|
|
|
|
 |
-
Step 4
-
Attach Cable to Fuse or
Fuse Clip
After safely removing fuse,
connect Vcc(+) (red wire)
directly to the fuse by either
using a wrapping method or by
purchasing a wiring clip from
your local auto parts retailer. |
|
|
|
|
|
|
 |
-
Step 5
-
Return Fuse To Proper
Location
After
connecting Vcc(+) (red wire), return
the fuse with attached cable to the
proper location in your fuse panel
box. |
|
|
|
|
|
|
|
 |
-
Step 6
-
Attach Ground Cable
Ground line (black wire) goes to
fuse box ground. Ground cable
(black) must connect with the
steel in your vehicle. If it
doesn't connect with a steel,
the vehicle black box car camera
may not function properly or the
device may be damaged. If you do
not have an accessible fuse
panel ground, you may install a
screw directly to metal to serve
as your grounding location. |
|
|
|
|
|
|
 |
-
Step 7
-
Connect Power To Camera
Connect the fuse box wiring
module to the Vehicle Black Box
Car Camera. Please insure camera
is functioning properly then
organize and conceal cables. |
|
|
|
|
|
|
|
|
-
Fuse Box Wiring Module
-
Hard Wire the Car Camera
Directly to the Fuse Panel
With this accessory you can hard
wire the car camera directly to
the fuse panel. The wiring
harness has a power sensor that
will stop the camera from
recording if it depletes the
battery below a certain point.
|
Model:
SCI-DR200-WM |
Price: $19.99 |
|
|
|
|
|
|
|
Notice
This
device may not be used to violate the privacy rights of
others. In no way will Spy Chest Inc or its subsidiaries
or partners be held responsible for inappropriate use of
these products.
IT IS THE SOLE RESPONSIBILITY OF THE BUYER TO CONSULT LEGAL
COUNSEL FOR THE INTERPRETATION OF ANY LAWS APPLICABLE TO
THE AREA OF INTENDED USE OF THESE PRODUCTS.
|
|
